Scania SDP3 Diagnos & Programmer v2.58.1.6 no Dongle Unlock full

Scania SDP3 Diagnos & Programmer v2.58.1.6 no Dongle
Unlock full

Scania Diagnos & Programmer 3 (SDP3) communicates with Scania vehicles and Scania industrial and marine engines. The program has been developed to support the electrical system with CAN communication.

Highest level access
Internal Scania
Industry & Marine
Authorized Scania Workshops
Bodybuilder

Scania SDP3 Features:

Check and adjustements

Conversion
Maintenance
Campaign
Bodywork
Fault Codes
Fault Reporting
Programming of Control units

Release notes:

The program supports the following vehicles:
L, P, G, R and S series (2016-)
P, G, R and T series (2003-)
F, K and N series
as well as the following engines:
P96
E2011

Need Net framework 4.5 installed on system. windows 7 or 8 will be better.
In order to install SDP3, administrator rights are required.
Note:The VCI must not be connected to the computer during the installation of SDP3, especially not if SDP3 is installed for the first time.