VW-Audi AirBag OBD Resseter

VW-Audi AirBag OBD Resseter

Very simple user instruction: connect this tool to VW-Audi OBD II connector (for cars from year 1996-2002 ). This project consist of PCB protel file, dump for ATMega16 including security bits configuration and user manual. It is handheld device and does not require any PC. Works with these cars: Older VW-Audi cars. Sensors with white or orange 30-pin connector. - AUDI A4, A6, A8 1994-1997: Airbag V BOSCH: 8A0 959 655 C (Bosch 0 285 001 038), 8A0 959 655 K (Bosch 0 285 001 155), 8A0 959 655 K (Bosch 0 285 001 151) - Crash data erase, Fault erase; - VW - Golf III, Passat B4, Sharan: 1J0 909 603 SIEMENS - Crash data erase, Fault erase; VAG cars 1997-1999 airbag sensor with yellow or orange 50-pin connector. - VW - Golf IV, Passat B5: 1J0 909 609, 1J0 909 607 - SIEMENS - Crash data erase, Fault erase; - AUDI A3, A4, A6, A8 <1999: Airbag 7 BOSCH - 4B0 959 655 C, 4B0 959 655 J, 4D0 959 655 C, 4D0 959 655 H, 8D0 959 655 C, 8D0 959 655 L, 8L0 959 655 F - all Bosch Airbag 7 - Crash data erase, Fault erase; Audi cars 2000 -2002 airbag sensor with yellow 84-pin connector. - Audi A2, A3, A4, A6, A8 - 1999<: Airbag 8 BOSCH - Crash data erase, Fault erase (can erase "Controller Malfunction"); - 8L0 959 655 G (Bosch 0 285 001 352) and others with HC12 processor; - 4D0 959 655 J (Bosch 0 285 001 266), 8D0 959 655 J (Bosch 0 285 001 276), 8D0 959 655 F (Bosch 0 285 001 270), 8D0 959 655 M and others with National CR16 (44 PLCC); VW cars 2000-2004 airbag sensors with yellow 75-pin connector. - VW - Golf IV, Passat B5, Sharan: 6Q0 909 605 A, 6Q0 909 605 B - SIEMENS - Crash data erase, Fault erase; - VW - Golf IV, Passat B5, Sharan: 1C0 909 605 C, 1C0 909 605 F, 1C0 909 605 H, 6Q0 909 605 C - SIEMENS - Crash data erase, Fault erase; - VW - Passat B6: new SIEMENS - Crash data erase, Fault erase; - VW- Polo; New Audi, VW from 2002 airbag sensors. Airbag sensor from VW-Audi (A3, A4, A6, A8 2002-2005, Touareg) have diagnostic by CAN bus. But K-line is still used. Some times K-line is not connected to OBDII connector. To repair these sensors you must remove it from the car and connect on the table. Is possible to read and write airbag sensor internal CR16 (80 QFP) EEPROM memory by K-line. Works with all VW-Audi airbag sensors with National CR16 (80 pin QFP) inside.